Methods of cleaning building stones

There are different ways to clean a building stone. Natural stone surfaces are beautiful, but if they don’t properly maintain, they’ll lose their beautiful appearance and their surface luster. And, they need to be cleaned again. To clean stones, you should use natural cleaning products for natural stones. In the following, we will be acquainted with the method of cleaning different stones.

Undoubtedly, in the most houses, stone is used in different parts, especially on the floor of the building. And, one of the concerns for people using natural stones is how to clean them. Before cleaning, it is better to know a bit about the type of stone used in your building. Because the types of stones are different, and each one has its own characteristics. When you have information about your building stone, it will help you directly in the way of maintaining and cleaning it. First you should know about your stone and its features, then it is time for learning methods of cleaning it, which are discussed below:

Cleaning and polishing the floor and wall stone

Indoor building stones are usually used for kitchen counter tops, between the cabinets, flooring and etc. Unfortunately, some unaware people use chemical detergents to clean natural building stones. Using them work well at first and the surface becomes completely shiny, but after a few years, the stone won’t look the same as before and it will start to crack or break.

The best way to clean the flooring stone is to first gently sweep the debris on it with a soft broom. Be careful, this will prevent the surface of the stone to be cracked. In a bucket with cold water, mix some special stone and ceramic cleaner until it foams. Clean the stone completely using a cloth or a soft cloth so that no detergent remains on the stone and finally dry the stone with a soft cloth. Be sure to use cold water to clean the stone because hot water destroys the enzymes in the detergent.

Cleaning the facade of a building

The method of cleaning stone in the facade needs more care and attention. In order to wash and clean the façade stone, you should keep in mind the humidity level of the nearby area. Because, moisture is the main cause of the stone erosion. This issue can be effective for the frequency of washing the facade. There are different ways to wash and clean the facade, and each of these methods is suitable for its own conditions. On the other hand, the level of air pollution also affects the choice of washing method, for example, the method of cleaning and washing the façade of a building that is in an area full of smoke will be different from the facade that has dirty oily stains.

Types of stone washing methods

In general, there are three types of stone cleaning methods in the exterior section:

  • Washing with water
  • Washing with chemicals
  • Washing by shaving method

Usually, washing by shaving method is done with the help of sand or gravel and it is not very recommended, because in this method, in addition to removing dirt and pollution, some parts of the stone surface is rubbed and it cause damage to the stone. Therefore, do not use this method except in necessary cases. Washing methods with water and chemicals are both suitable and safer for cleaning the façade stone, but each can be done on certain materials.

Important key points in cleaning the building stone

An important point in the field of stone cleaning in all sectors is that the stones must be cleaned quickly when they are contaminated. When the stain appears on the surface of the stone, you should quickly clean it and if you don’t, the stain may be difficult to remove or even not completely removed later.

When the stain remains on the stone, especially if it is a tea or coffee stain, it won’t be easy to clean. In the kitchen counter, we usually use suitable stones. But usually, this part of the kitchen is vulnerable to get many stains. But don’t worry, if you clean the stains from the beginning, they won’t decrease the life of the stone and they will be less trouble for you.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published.